PLA:
Temp: 205-215 Standard Printers.
Temp: 220-240 High speed printers, remember that although the pla is not for such high temp but when printing at high speed the material is not affected, its crystallization point is higher.
Speed: Our filament is made with PLA 850 material which is for better finish, higher resistance and made for high speed.
Up to 400 mm/s has been tested, remember that you can vary the speed with volumetric speed, it is always recommended to test when you handle these two types of speeds in the slider.

PETG:
Temp: 235-250
Speed: up to 350mm/s
Layer Fan: Depends on your machine, but if not bamboo I recommend 0-10% layer fan or turbine.
Bed: 70 Degrees
Filling: It will always depend on the part you are making.
Not recommended to use Carbon Fiber Materials with AMS, it is just a recommendation.
Always make temperature towers is recommended with the materials to be used, no matter what brand it is, it is a recommendation.

ABS:
Temp: 240-250
Speed: Up to 300mm/s
Coating Fan: on certain printers by test 0% - 20%.
Bed: 100 degrees for the first 15 minutes before printing and then down to 80 at the start of printing
Filling: Depends on the part
It is recommended that the machine is closed or in a place where it does not receive air currents and change the temp as it can create warping and cracking in the piece.

TPU:
Temp: 220-230
Speed: Non high speed machines: 35-40 mm/s for best quality.
Filling: Depends on how flexible you want the part to be. Filling is between 5-12%.
Bed: 65 degrees

ASA:
Temp: 250-260 degrees
Bed: 80 degrees
Speed: up to 300mm/s
Ventilation: 80%.
Filling: Depends on the part and the maker

PLA:
Temp: 205-215 Standard Printers.
Temp: 220-240 High speed printers, remember that although the pla is not for such high temp but when printing at high speed the material is not affected, its crystallization point is higher.
Speed: Our filament is made with PLA 850 material which is for better finish, higher resistance and made for high speed.
Up to 400 mm/s has been tested, remember that you can vary the speed with volumetric speed, it is always recommended to test when you handle these two types of speeds in the slider.

PETG:
Temp: 235-250
Speed: up to 350mm/s
Layer Fan: Depends on your machine, but if not bamboo I recommend 0-10% layer fan or turbine.
Bed: 70 Degrees
Filling: It will always depend on the part you are making.
Not recommended to use Carbon Fiber Materials with AMS, it is just a recommendation.
Always make temperature towers is recommended with the materials to be used, no matter what brand it is, it is a recommendation.

ABS:
Temp: 240-250
Speed: Up to 300mm/s
Coating Fan: on certain printers by test 0% - 20%.
Bed: 100 degrees for the first 15 minutes before printing and then down to 80 at the start of printing
Filling: Depends on the part
It is recommended that the machine is closed or in a place where it does not receive air currents and change the temp as it can create warping and cracking in the piece.

TPU:
Temp: 220-230
Speed: Non high speed machines: 35-40 mm/s for best quality.
Filling: Depends on how flexible you want the part to be. Filling is between 5-12%.
Bed: 65 degrees

ASA:
Temp: 250-260 degrees
Bed: 80 degrees
Speed: up to 300mm/s
Ventilation: 80%.
Filling: Depends on the part and the maker